Tap the button below to connect to your LOCKCAR module via Bluetooth. Make sure Bluetooth is enabled on your phone.
bluetooth tag
RSSI: 0=-60dBm · 1=-70 · 2=-78 · 3=-85 · 4=-92
shock sensor (LIS2DH12)
Settings are saved and the module restarts. BLE connection will drop for ~35 seconds.
administration
Reset = erases MAC/settings from NVS and restarts with defaults.
can bus
can bus
saved PIN
pin length
state
combo authorization
match (latched)
last match
match progress
last input
available inputs
Green = added from the CAN SCANER. Use them for the PIN. Identify new ones in the CAN SCANER tab and press + input.
saved PIN
no combo programmed
The sequence that disarms the immobilizer. On match: GPIO20 ? HIGH + permanent authorization, GPIO8 ? LOW / GPIO3 ? HIGH and flash lights on CAN.
combo learning
Press SET PIN, perform 48 real actions (stalk / steering-wheel buttons / turn signals), then press SAVE PIN.
input feed (live)
Actions detected on the CAN bus appear here in real time.
installer access · CAN SCANER
Restricted area. Enter your personal 4-digit installer code to continue.